Are you sure you want to leave this community? Leaving the community will revoke any permissions you have been granted in this community.
Linkage disequilibrium (LD) analysis provides information on the evolutionary aspects of populations. Recently, haplotype blocks have been used to increase the power of quantitative trait loci detection in genome-wide association studies and the prediction accuracy of genomic selection. Our objectives were as follows: to compare the degree of LD, LD decay, and LD decay extent in popcorn populations; to characterize the number and length of haplotype blocks in the populations; and to determine whether maize chromosomes also have a pattern of interspaced regions of high and low rates of recombination. We used a biparental population, a synthetic, and a breeding population, genotyped for approximately 75,000 single nucleotide polymorphisms (SNPs). The sample size ranged from 190 to 192 plants. For the whole-genome LD and haplotype block analyses, we assumed a window of 500 kb. To characterize the block and step patterns of LD in the populations, we constructed LD maps by chromosome, defining a cold spot as a chromosome segment including SNPs with the same LDU position. The LD and haplotype block analyses were also performed at the intragenic level, selecting 12 genes related to zein, starch, cellulose, and fatty acid biosynthesis. The populations with the higher and lower frequencies of |D'| values greater than 0.75 were the biparental (65-74%) and the breeding population (26-58%), respectively. There were slight differences between the populations regarding the average distance for SNPs with |D'| values greater than 0.75 (in the range of approximately 207 to 229 kb). The level of LD expressed by the r2 values was low in the populations (0.02, 0.04, and 0.04, on average) but comparable to some non-isolated human populations. The frequency of r2 values greater than 0.75 was lower in the biparental population (0.2-0.5%) and higher in the other populations (0.2-1.6%). The average distance for SNPs with r2 values greater than 0.75 was much higher in the biparental population (approximately 80 to 126 kb). In the other populations, the ranges were approximately 6 to 19 and 6 to 35 kb. The heatmaps for the regions covered by the first 100 SNPs in each chromosome, in each population (1 to 3.3 Mb, approximately), provided evidence that the comparatively few high r2 values (close to 1.0) occurred only for SNPs in close proximity, especially in the synthetic and breeding populations. Due to the reduced number of SNPs in the haplotype blocks (2 to 3) in the populations, it is not expected advantage of a haplotype-based association study as well as genomic selection along generations. The results concerning LD decay (rapid decay after 5-10 kb) and LD decay extent (along up to 300 kb) are in the range observed with maize inbred line panels. The LD maps indicate that maize chromosomes had a pattern of regions of extensive LD interspaced with regions of low LD. However, our simulated LD map provides evidence that this pattern can reflect regions with differences in allele frequencies and LD levels (expressed by |D'|) and not regions with high and low rates of recombination.
Pubmed ID: 31553737
Publication data is provided by the National Library of Medicine ® and PubMed ®. Data is retrieved from PubMed ® on a weekly schedule. For terms and conditions see the National Library of Medicine Terms and Conditions.
A Java based software tool designed to simplify and expedite the process of haplotype analysis by providing a common interface to several tasks relating to such analyses. Haploview currently allows users to examine block structures, generate haplotypes in these blocks, run association tests, and save the data in a number of formats. All functionalities are highly customizable. (entry from Genetic Analysis Software) * LD & haplotype block analysis * haplotype population frequency estimation * single SNP and haplotype association tests * permutation testing for association significance * implementation of Paul de Bakker's Tagger tag SNP selection algorithm. * automatic download of phased genotype data from HapMap * visualization and plotting of PLINK whole genome association results including advanced filtering options Haploview is fully compatible with data dumps from the HapMap project and the Perlegen Genotype Browser. It can analyze thousands of SNPs (tens of thousands in command line mode) in thousands of individuals. Note: Haploview is currently on a development and support freeze. The team is currently looking at a variety of options in order to provide support for the software. Haploview is an open source project hosted by SourceForge. The source can be downloaded at the SourceForge project site.
View all literature mentionsSoftware program for constructing linkage disequilibrium (LD) maps. (entry from Genetic Analysis Software)
View all literature mentions